Dangerous Goods Declaration (IATA)

Shipper’s Declaration (IATA Section 8)

A description of the Shipper's Declaration that shippers must use when shipping dangerous goods under the IATA Dangerous Goods Regulations.

Shipper's declaration of dangerous goods (IATA)

  • UPS Shipper's Declaration
    When opting to comply with regulations promulgated by IATA, a Shipper’s Declaration must accompany each dangerous goods package or shipment unless shipping a multi-piece shipment to one consignee in which case the shipper may either place a shipper’s declaration on every package in the consignment, or provide shipment-level information on a Shipper’s Declaration on the lead package of the shipment. Each DG package must have DG information assigned in WorldShip or the UPS-compatible shipping software used by the shipper.

    UPS requires three original Shipper's Declarations on each hazardous materials package or if a multi-piece shipment as described above, three original Shipper’s Declaration on the lead package.
    If more than one hazardous material is in a package, one shipper's declaration must be used listing all materials. UPS allows a maximum of three compatible hazardous materials in one package.

The following information must appear as indicated (references to IATA):

  • Shipper: Enter the shipper's full name and address – 8.1.6.1.
  • Consignee: Enter the full name and address of the consignee – 8.1.6.2.
  • Air Waybill Number: For air cargo shipments, the air waybill number is entered in this field. For small package shipments, the tracking number is entered – 8.1.6.3.
  • Page X of X Pages: Enter the page number of the shipper’s declaration. If there is only one page for the shipment, note that the shipper’s declaration is "Page 1 of 1 Pages" – 8.1.6.4.
  • Aircraft Limitation: Delete the type of aircraft that does not apply – 8.1.6.5.
  • Airport of Departure: Leave blank.
  • Airport of Destination: Leave blank.
  • Shipment Type (Radioactive/non-Radioactive): Delete the shipment type that does not apply – 8.1.6.8.
  • Nature and Quantity of Dangerous Goods – 8.1.6.9.
    • UN or ID Number: Enter the UN or ID number for the material.
    • Proper Shipping Name: Enter the proper shipping name. (with Technical Name when required)
    • Class or Division: Enter the hazard class or division for the material.
    • Subsidiary Risk: Enter the subsidiary risk, if applicable. This subsidiary risk must be enclosed in parentheses.
    • Packing Group: Enter the Packing Group assigned, if applicable.
    • Quantity and Type of Packing: A description of the package and an indication of the quantity of material being shipped (use net quantity unless the regulations require gross mass; metric measure is mandatory)
    • Packing Instructions: The IATA Packing Instruction number must be noted in this column.
    • Authorization: Location for any Special Provision numbers, DOT special permits, LAA approval numbers, EX numbers or other pertinent authorization information.
  • Additional Handling Information – 8.1.6.11: The shipper uses this box to indicate the appropriate 24-hour emergency response telephone number (in conjunction with the ER Registrant information) or any special handling information relevant to the shipment.
  • Certification – 8.1.6.12: By completing this section, the shipper certifies that the package is in compliance with all rules and regulations.

The shipper is responsible for ensuring that all copies of the shipper's declaration are clear and legible.
If you have any questions about shipping hazardous materials with UPS, please call the UPS Hazardous Materials Support Center at 1-800-554-9964.